Actions for setting up a 1000-liter compressor with a standing (vertical) tank (second part)

Step 3 – Connecting the cables to the electrical panel of the 1000 liter compressor with a standing tank

To start and start the compressor, we first connect the electric cable (three strands) that came out of the electric motor to the contactor of the electrical panel. There are three strands of electric cables and each of them must be completely connected to the contactor of the electrical panel. Then we connect a four-wire power cable from the factory’s input power to the miniature switch of the electrical panel

At this stage, you must be careful to connect the neutral wire to the terminal under the Miniato key.

 

Buying a compressor

If you are planning to buy a compressor for your device for the first time, first read the catalog and the instructions for setting up the device. In most cases, the company producing the equipment specifies the specifications of the compressor required for the device in the catalog.

The part of your plant and system equipment that requires the highest working pressure is the compressor’s working pressure setting. 1.5 is better bar Add to the minimum pressure you need to compensate for the pressure drop that often occurs in the compressed air system (pipes, dryers, etc.).

After determining the pressure, calculate the total air consumption of each machine in your factory. This number will be equal to the volume of air produced by the new compressor.